Industrial Reverse Osmosis |
|
|
Industrial RO has many applications. from boiler feed water, to car wash water, to process water. New applications include grey water recycle water.
RO systems work by forcing raw water through a membrane (at high pressure). Only the water molecules get through and all the minerals are concentrated in a waste stream. Typical industrial RO's can remove 97% of the minerals and are 75% efficient (25% waste). Higher recovery or mineral content systems are available - see table |
|
|
PRF-RO
Light industrial "on demand" RO. Flow rate - 70 l/hr (at 10C & 4 bar) Recovery : 22% Inlet pressure MUST be between 3 & 5.5 bar Inlet TDS: 50 to 2000 mg/l Size: (hxdxl) : 268mm x 280mm x 509mm |
|
Budget RO's
Light industrial RO Flow rate - 80 or 130 l/hr (at 15C ) Recovery : 50% mineral reduction: 95% Pump included Size approx: (hxwxd) : 370mm x 800mm x 370mm |
|
Horcea OC 750 Catering RO
This RO has been developed in collaboration with professionally experienced end users in order to achieve the optimal quality required for use in professional kitchens.
|
|
Alfa 250 Light Commercial RO
Flow rate: 250 l/hr
Recovery 50% Mineral reduction 97+% Single phase Digital display |
|
RO 120-500l/hr Wall/Standing type
Flow rate: 120 to 500 l/hr Recovery 75% Mineral reduction: 97+% Single phase Two digit display, conductivity measurement, volt free alarm, level control operation. |
|
RO 50-500l/hr Wall/Standing type Digital
Flow rate: 120 to 500 l/hr Recovery 75% Mineral reduction: 97+% Single phase 2 x 16 digit display, self diagnostics, programmable parameters |
|
Standard RO 600-12,000 l/hr
Flow rate: 600 to 12000 l/hr Recovery 75% Mineral reduction: 97+% Requires softened water |
|
Antiscalant Dosing RO 1650-30,000l/hr
Flow rate: 600 to 12000 l/hr Recovery 75% Mineral reduction: 97+% Has fittings for antiscalant dosing Dosing rig option |
|
Brackish Water RO
Flow rate: 250 to 27500 l/hr Recovery 50% Mineral reduction: 97+% For TDS waters up to 5000 mg/l |
|
Sea Water RO
Flow rate: 650 to 20000 l/hr Recovery 50% Mineral reduction: 97+% For TDS waters up to 5000 mg/l |
|
Permeate Staged RO (better quality) Flow rate: 220 to 2000 l/hr Recovery 75% Mineral reduction: 99% Permete water passes through two RO stages for better quality |
|
Ultra Pure Water (EDI)
Flow rate: 150 to 2000 l/hr Recovery 75% Mineral reduction: 99+% (<1uS) RO combined with an electro-deionisation unit to produce better than 1uS |
|
Ultra Filtration Units
Flow rate: 500 to 30000 l/hr Recovery 95% Takes out colloidal colour and particles above 0.01um. Often used as pre treatment for RO systems. Self cleaning using the permeate water pushed back through the system. |